Ez-dupe DVD/CD & USB 10 copy Duplicator Instrukcja Użytkownika

0 User’s Manual Version 3.0 EZ DUPEDVD/CD Duplicator

9 6. Select Source – This command will allow you to change the source drive to any one of the drive(s) inside the unit, including the HDD (if inst

10 7.1.3 System Info: Checks the model number, buffer memory and firmware version of the duplicator.  Press ENT 7.2 Erase Disc 7.2.1 Quick Era

11 7.5 Eject All Discs: Performs a simultaneous ejection of all of the optical disk drive(s) on the duplicator.  Press ENT  All disc tra

12  Press ENT    or  to select seconds and press ENT to confirm 8.2 Display Mode: Changes the display readout during the performance of

13 8.4.5 Eject All Trays: Eject all drives. 8.5 Reader Speed: Sets the reader speed for the duplicator to read the master disc(s). The speed

14 8.9.2 Start-up Menu: Sets the command to be displayed first when the machine is powered up and initialized. All primary commands are available

15 If Enable is selected, a password must be entered using the following guidelines: Use  or  to select the character desired. Press E

16 9.2 Disc => Image: Transfers the information from the master CD/DVD disc to the HDD. After the image(s) transfer is complete, the reader dr

17   Press ENT to confirm  There are 8 characters for each image name. No empty space allowed in the image file name. Press ESC to cancel the p

18 b. Remake the master disc on another disc. Master disc may be of poor quality or with error(s) that make duplication difficult or impossible. c.

1 TABLE OF CONTENTS Introduction 2  Setup 11  HDD Manager 15 LCD Front Panel Overview 2 o Auto Start Time 11 o Select Image 15 Menu Overv

19 Copyright © 20 10. All rights reserved. Supported Formats:

2 Introduction: Thank you for purchasing a SATA DVD/CD Duplicator. This duplicator is specifically engineeredto run a stand-alone SATA DVD/CD

3 Menu Overview: Below is a quick reference chart of the functions available on SATA DVD/CD Duplicators. Power on the system to access the menu fun

4 7.4.2. Close Disc Closes the target discs when all of the track(s) are burned on to all target discs. Note: The copied disc(s) will NOT play back w

5 8.9 ADVANCED SETUP 8.9.1 Power On Time Sets system warm up time from 5 sec to 99 sec. Default is 15 seconds. 8.9.2 Startup Menu

6 Functions: 1. Copy – This command will copy the master disc placed in the designated Source Drive to all target discs in the Writer Drives. This

7  Press ENT to load disc and execute Test  Analyze source disc    Start simulation   Finish and eject discs 3. Compare – This command

8 To start the Copy & Compare process: 1. Power on the machine (if not already on). 2. Eject disc tray of the Source Drive and place the master